Post by papahemi on Nov 19, 2022 16:04:04 GMT 12
Āue!
As I was replacing the stylus on my Lab 80 the connector block on the headshell snapped in two. It is made of clear plastic of some sort and is very brittle. Thus the snap is not clean and not likely to be able to be glued. I am considering options:
Does anyone have any thoughts or even perhaps a spare headshell lying around.
Thanks in anticipation.
As I was replacing the stylus on my Lab 80 the connector block on the headshell snapped in two. It is made of clear plastic of some sort and is very brittle. Thus the snap is not clean and not likely to be able to be glued. I am considering options:
- source a replacement headshell with connecting block intact (rocking horse poo - but you never know)
- crafting a replacement connector block - or having one 3d printed
- bypassing the block, rewiring tonearm with sufficient length to run to cartridge
Does anyone have any thoughts or even perhaps a spare headshell lying around.
Thanks in anticipation.
We are what we pretend to be, so we must be careful about what we pretend to be.